Description Of Symbols; General Safety - Silverline 637925 Manual Del Usuario

GB

Description of Symbols

The rating plate on your tool may show symbols. These represent
important information about the product or instructions on its use.
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Hot surface
Keep sufficient distance from the machine
This product emits poisonous fumes
Risk of electrocution
Combustion engines produce carbon monoxide. Do not
start or use in enclosed spaces
The machine is not suitable for the use of electronic
devices or circuits
Do not use petrol tools where there is a risk of explosion or
fire from combustible material, flammable liquids, flammable
gases, or dust of an explosive nature
If the engine has been running it will be very hot. DO NOT
TOUCH.
Conforms to relevant legislation and safety standards
Environmental Protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice
6
Specification
Engine Type: ................................................ 4 Stroke OHV
Power: ......................................................... 5.5HP
Fuel Type: .................................................... Unleaded Petrol
Fuel Tank Capacity ...................................... 12L
Maximum Continuous Run Time .................. 12.5Hrs
Sound Level ................................................ 96dB(A)
Maximum RPM............................................4000RPM
The sound intensity level for the operator may exceed 85dB(A) and
sound protection measures are necessary.
As part of our ongoing product development, specifications of
Silverline products may alter without notice.
Generator
Output:
Type: ............................................... Brushless, Revolving Field,
AC Voltage
50Hz: .............................................. 110V/230V
Rated Output
50Hz: .............................................. 2.05kVA
Max. Output
50Hz: .............................................. 2.3kVA
Steady State Voltage
Adjust Rate ..................................... Between ± 8%
Steady State Frequency
Adjust Rate ..................................... Less Than 6%
Voltage Waveform
Twist Rate ....................................... Less Than 25%

General Safety

Carefully read and understand this manual and any label attached to
the tool before use. Keep these instructions with the product for future
reference. Ensure all persons who use this product are fully acquainted
with this manual.
Even when used as prescribed it is not possible to eliminate all residual risk
factors. Use with caution. If you are at all unsure of the correct and safe
manner in which to use this tool, do not attempt to use it.
Keep guards in position
• Where guards exist keep them in position, in good working order,
correctly adjusted and aligned. Never attempt to use a tool if any of
the supplied guards are missing. If any guards are damaged, replace
before use
Remove adjusting keys
• Where adjusting keys exist, ensure they are removed prior to using the
tool. Always check to see that keys and adjusting devices are removed
from the tool before use
Clean the work area
• Accidents can occur where benches and work areas are cluttered or
dirty. Keep floors clear and avoid working where the floor is slippery. If
working outdoors, be aware of all potential slip and trip hazards before
using this tool
Trained, competent persons
• This tool should be used by trained, competent persons only
Self-exciting, 2-pole,
Single Phase