Kenwood KVT-M707 Manual De Instalación página 4

Connection
For the sake of safety, be sure to
connect the parking sensor.
Connect to the vehicle's parking brake detection
switch harness using the supplied relay connector.
Ignition key switch
Car fuse box
(Main fuse)
+
Antenna Cord
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
To connect the Kenwood navigation system,
consult your navigation manual.
Depending on what antenna you are using, connect either to the
control terminal of the motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
When using the optional power amplifier, connect to its power
To "EXT.AMP.CONT. " terminal of the amplifier having the external
4
|
English
To vehicle's reverse lamp harness
To car light control switch
To Steering remote
ACC
A
B
Car fuse box
C
FM/AM antenna input
Accessory 4
C
B
control terminal.
amp control function.
Parking sensor wire (Green)
Reverse sensor wire (Pink)
Dimmer control wire (Orange/White)
Steering remote control input
(Light Blue/Yellow)
Ignition wire (Red)
A
Battery wire (Yellow)
B
Ground wire (Black) - (To car chassis)
C
AV OUTPUT
AV INPUT 2
VIDEO L R L
FM /AM ANTENNA AV INPUT 1
VIDEO L R R
Ground wire (Black) - (To car chassis)
Battery wire (Yellow)
Mute wire (Brown)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
External amplifier control wire (Pink/Black)
Monitor unit
Accessory 3
PRK SW
REVERSE
ILLUMI
REMO.CONT
(5A)
ACC
BATT
Receiver unit (front side)
SUB
PRE OUTPUT
REAR FRONT
R-CAM V-IN L L L
POWER
VIDEO
R R R
Accessory 1
(10A)
MUTE
ANT. CONT
P CONT
EXT.CONT