Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions - continued
Power Switch
Always turn power switch off when not in use. Permanent battery
damage may occur if the unit is allowed to self-discharge in the ON
position.
Removing the Battery Pack
Verify the Power Switch is in the OFF position.
Push down the release button at the back of the battery and
slide the battery away from the PullzAll body.
Installing the Battery Pack
Verify the Power Switch is in the OFF position.
Slide the battery pack in to the body, making sure that the
latch is fully engaged (
release button in the top position
Spooling Rope In and Out
Do the following:
•
Always take your time to assess your situation and plan your lift/pull carefully.
•
Always, prior to a lift/pull, inspect mounting structure, the product, slings and/or other accessories for signs of
damage. Replace damaged components prior to a lift.
•
Always know the weight of the load and make sure the rigging, hoist, and mount will carry the weight.
•
Always verify that the load is directly under or in line with the product, the rope is not tangled or kinked, and that
all people are standing clear of the load.
•
Always take up any slack in the rope slowly. Begin the lift slowly. If there is any evidence of overloading,
immediately lower the load and correct the situation.
•
Always avoid shock loads to the product caused by rapidly lifting or bouncing a load.
•
Always inspect and carefully rewind rope after each use. Cuts, kinks, or frayed areas reduce the strength of rope.
Replace rope if damaged.
•
Always apply tension to the rope when spooling rope out. If no tension is applied, the rope can ball up inside the
product, causing damage.
Avoid the following:
•
Never use the Load Limiter to stop the travel of the load or to stop the hook against the fairlead.
•
Never use the load limiting feature to measure the load.
•
Never spool out rope past the length of red rope.
•
Never attempt to lift/pull an off-center load of any kind. This can cause the load to swing dangerously. Make sure
the load is directly under the product.
•
Never allow the load to swing or twist.
Overloading & Overheating
Approximate load can be determined from the Load Indicator Display (feature #5), where each bar on the display is
approximately 125 lbs (57 kg). When a load greater than 1000 lbs (454 kg) is applied, the product will stop pulling and
the last two bars on the display will flash red until the unit can be used again. If this happens, take tension off of the
rope and adjust the load to be less than 1000 lbs; do not attempt to apply the same load if the overload sensor has
tripped, as this can be harmful to the product.
If the PullzAll will not spool in or out, verify that the Load Indicator Display is no longer flashing and that the battery is
still fully engaged and has an adequate charge. If this does not solve the problem, contact the Warn Customer Service
department.
The PullzAll is rated for intermittent pulling. If pulling large loads (750-1000 lbs), do not pull more than 10 ft before
letting the unit and battery return to room temperature. If repeated high loads or long distances must be applied, a
winch or hoist rated for industrial use would be suggested.
).
PAGE 8
75443 Rev. B0
Publicidad
Tabla de contenido
