Vertilux VTi Celtic 35 Serie Manual De Programación página 7

Setting or modifying the lower limit
CASE #1
Current limit
Desired lower limit
If the current lower limit is above the desired
limit, follow the procedure below, depending on
the position of the motor.
MOTOR ON THE LEFT
1.
Rotate the hexdriver
modify the current lower limit.
2. Press the down button
the new limit. Verify if your current condition is
case 1
the one described in
procedure again as needed in each case until
reaching the desired limit.
Take into consideration:
turn of the motor tube.
vertilux.com
6
© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.
Press the down button
until the motor stops. Check the current position
of the lower limit, and follow either procedure,
depending on your case.
MOTOR ON THE RIGHT
counter-clockwise "+"
DOWN
BUTTON
to test the position of
2
or and perform the
7 full turns of the hexagonal grey or yellow limit setting screws equals to 1
DOWN
BUTTON
on the remote control
If the current lower limit is below the desired
limit, follow the procedure below, depending on
the position of the motor.
MOTOR ON THE LEFT
1.
to Rotate the hexdriver
the the current lower limit.
2. Press the up button
the desired lower limit and then press the
button
to test the position of the new limit. Verify
if your current condition is the one described in
case 1 2
or and perform the procedure again as
needed in each case until reaching the desired
limit.
CASE #2
Desired lower limit
Current limit
MOTOR ON THE RIGHT
clockwise "-"
to modify
UP
BUTTON BUTTON
until the shade is above
DOWN
down