Vertilux VTi Celtic 35 Serie Manual De Programación página 8

Adding an additional remote control or
"cloning" a channel
A previously programmed remote can be used in order to add a new remote or operating channel.
Also, you can copy one channel to another in the same remote control using this procedure.
1.
Using the previously programmed
remote, select the desired channel using the
channel selector button, then press and hold the
stop button
for about
2. Using a new remote, select the desired
channel using the channel selector
up button
then press the
Vertilux shades are now paired with the new
remote or channel.
Changing to tilt or jog mode
Tilt or jog mode initiates a short motor movement when pressing either up or down buttons.
The tilt or jog mode is convenient for Venetian Blinds, Wood Blinds and
since it allows the jogging or tilting of the slats in a more precise way. When this mode has been
programmed, the up or
setting, otherwise when you press the
Repeat the same procedure if you want to return to the
1. Press and hold the
until the motor "jogs".
2. stop button
Release the
about 2 s. The motor will
or
The tilt jog mode has been programmed.
Vertilux
5 s until the motor "jogs".
button, and
until the motor "jogs".
down button must be pressed for
up and
stop button for about 5 s
and press it again for
"jog" again.
© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.
PREVIOUSLY
PROGRAMMED
REMOTE CONTROL
NEW REMOTE
CONTROL
OR CHANNEL
3 s to return to the motor's original
down button the motor will do short movements.
tilt or jog mode.
BUTTON
BUTTON
STOP
BUTTON
UP
BUTTON
Neolux Dual Shades
®
STOP
STOP
vertilux.com
7