Dictator DICTAMAT 50 KW Manual Tecnico página 14

Technical Manual
DICTAMAT 50 KW
2) Mounting
3) Adjusting the
Deflection Roller
Oblong hole for
adjusting the height of
the deflection roller
Ill. 4b
4) Fixing the Kevlar Rope
to the Door
Page 02.057.04
C) Mounting of the DICTAMAT 50 KW - continuation
The DICTAMAT 50 KW is fixed to the rail via the oblong holes described
on the previous page. For further stabilization the carrier bracket of the
DICTAMAT 50 KW can additionally be fixed with the oblong holes 
according to ill. 2.
ATTENTION: Do not yet tighten the screws completely, only after the
Kevlar rope has been fixed.
The height of the pull rope is determi-
ned by means of the deflection roller.
This makes the DICTAMAT 50 KW
independant of the used rail.
The oblong hole allows for an 30 mm
adjusting range.
IMPORTANT: the deflection roller
has to be positioned in a way that the
pull rope runs horizontally!
The deflection roller has to move freely
and may not touch the rope coming-off
prevention device or the rail.
For an easy fixing to the door the Kevlar rope of the spring rope pulley
is provided with an eyelet for M5 screws. The eyelet can be fixed either
to the wheel hanger or directly to the door leaf. The rope should run as
horizontally as possible and may not chafe on sharp edges.
If necessary the position of the DICTAMAT 50 KW has to be adjusted.
As soon as the DICTAMAT 50 KW has been positioned correctly all
fixing screws are finally tightened.
ATTENTION: In case the Kevlar rope has accidentally disengaged
from the guiding pulleys of the DICTAMAT 50, it is compulsory to guide
the rope corresponding to the illustration 4a and to make sure it runs
beneath the rope coming-off prevention device!
© DICTATOR TECHNIK GMBH Gutenbergstr. 9 • 86356 Neusäß • Germany
Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail info@dictator.de • 1043
Deflection roller
Ill. 4a