Reservoir Assembly - Ars2000 - 7 Gallon - Nautilus Dol-Fyn AR18 Guía De Uso Y Cuidado

RESERVOIR ASSEMBLY — ARS2000
1) Place the reservoir on the floor, open side down.
2) Install a plastic foot on the bottom of each leg. Turn the reservoir over so that
it sits open side up.
3) Decide if you wish to mount the sight gauge faucet on either the wide or the
narrow face of the reservoir. Install the sight gauge faucet by placing one
rubber washer onto the threaded end of the faucet and inserting the faucet
through the mounting hole in the reservoir. From inside the reser voir securely
tighten in place using the black plastic jam nut. Do not over-tighten jam
nuts. Avoid squeezing out rubber washer. Inspect to make sure that the sight
gauge is straight. Position the sight gauge retaining ring over the sight gauge
and hook it over the edge of the reservoir.
4) Install the reservoir plug by putting a rubber washer over the threaded
end of the plug and inserting it into the remaining hole in the reservoir.
From inside the reservoir, tighten into place using a black plastic jam nut.
5) Install the prepared post carbon filter cup by following the instructions
provided on page 11.
Note: If installing an ARS2000 / ARS3000 Pump Box, please refer to the
Pump Box Use and Care Guide (included with your Pump Box) in order to complete
the assembly of the reservoir. The demand Pump Box is an optional addition to
your system.
Black Plastic Jam Nut
Rubber Washer
Reservoir Plug
Black Plastic Feet
- 7 gallon (26.5 liter)
Sight Gauge Retaining Ring
Rubber Washer
Mounting Hole
8
Sight Gauge Faucet