Additional Installation Tips - SolarVenti SV14 Manual De Instalación

Basement Installation manual
UK
Additional installation tips
INTRO All measurements in this manual are applicable to the SolarVenti (K) basement
models only. The measurements CANNOT be used with our standard SolarVenti air
collectors (SV14, SV20, SV30).
Optimal Inblow: If possible the air inlet should be installed in the driest room and
the outlet in the most humid room in the basement – otherwise you risk spreading
the humid air throughout the entire basement.
Self‐Cleaning Principle: Self‐cleaning of the felt is started by turning off the system
in bright sunlight at least once a year. After a few hours the felt will be clean from
organic dust particles etc. and the solar air collector can be used again.
TOOLS The wall of the basement: Drilling through basement walls can be challenging and
the tools needed to make the hole will depend on the wall material. Contact your
local SolarVenti installer for further advice regarding the drilling and the installation.
The hole: Take care not to drill into cables etc.
The centre of the air inlet must be at least 100 mm below the basement ceiling.
The optimal diameter of the hole is Ø133 mm on the inside and Ø140 mm on the
outside. It is possible to use a Ø135 mm both inside and outside.
Screws: Screws for the mounting of the Solar Air Collector to the wall are not
included.
p. 6, 12, Cable: The cable of the Solar Air Collector may either go through the hole of the air
20, 22 inlet – as shown above – or a separate 6‐8 mm hole may be drilled in the position
desired.
p. 8 Insulation: Insulation of the pipe is needed. An insulation matt and aluminium cover
can be purchased from SolarVenti A/S.
p. 8, 14 Stands: Drill two holes in each rack and mount them to the wall with suitable
screws.
p. 10 Angle: Find the reference point of the Solar Air Collector's connection pipe. Mark
the grey area on the wall to indicate the position of the air inlet hole where the
drilling can be made. (Please note that an Extra Extension Kit will extend the
maximum length from 1010 mm to 2010 mm).
If you want to use the total length of the pipe G, you have to drill the hole on the
bottom line. If you drill a hole in the grey area, you will have to cut the pipe.
SolarVenti ® www.solarventi.com
IX. Additional installation tips
30