Assembly And Installation - Altair AL-2167 Instrucciones De Instalación

ASSEMBLY AND INSTALLATION:

INSTALLATION (Fig. 1)
1. Unscrew the lock nuts [B] from the fixture screws [G], but leave the fixture screws
[G] and hex nuts [E] on the mounting bracket [D].
2. Pull the power supply wires [H, J, & L] out from the outlet box [O], and attach the
mounting bracket [D] to the outlet box [O], using the mounting screws [F].
NOTE: This product is not for use with rectangular junction boxes.
3. Secure the fixture [A] onto the mounting bracket [D] with the lanyard hook [P] to
prepare for the next step.
4. Strip approximately 9.5 mm / 0.3 in / 0.3 po of insulation from each supply wire from
the outlet box [O]. Raise the fixture [A] to the wall, bringing the wall plate [N] close to
the outlet box [O]. Make the following wire connections using the wire connectors
[C]:
[H] White (neutral) supply wire to
[J] Black (hot) supply wire
[L] Supply ground wire
A
B
Q
N
Fig. 1
F
I
M
A. Fixture
B. Lock Nut
C. Wire Connector
D. Mounting Bracket
E. Hex Nut
F. Mounting Screw
G. Fixture Screw
H. White Supply Wire
I. White Fixture Wire
[I] White fixture wire
to [K] Black fixture wire
to [M] Fixture ground wire
D
E
C
K
J. Black Supply Wire
K. Black Fixture Wire
L. Supply Ground Wire
M. Fixture Ground Wire
N. Wall Plate
O. 4 in. Outlet Box
P. Lanyard Hook
Q. Washer
4
P
J
G
L
O
H