Cleaning And Care; Troubleshooting - HoMedics MIR-150 Manual De Instrucciones

C L E A N I N G A N D C A R E
CAUTION: before cleaning the unit, turn power off and remove from the charging base.
T O C L E A N T H E S U R F A C E
Clean the surfaces of the unit as needed with a dry, soft cloth.
NOTE: Never use water, alcohol or abrasive cleansers to clean the
surface of the unit. Doing so will result in malfunction or discoloration
of the unit.
T O S T O R E
Store in a safe, dry place, out of reach of children.
T R O U B L E S H O O T I N G
PROBLEM POSSIBLE CAUSE
Unit will not operate
• Unit is not charged
The LED light is not • Unit is not fully charged
bright enough
6
SOLUTION
• Charge the unit by connecting it to
the charging cord and plugging it
into a USB power source.
• Press and hold the POWER ON/OFF
button for 3-seconds to turn the
power on.
• Check circuits, fuses, try a different
outlet or USB power source.
• Fully charge the unit by connecting
it to the charging cord and plugging
it into a USB power source.
F C C S T A T E M E N T
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user authority
to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receive is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This class B digital device complies with Canadian ICES-003.
7