INTERPRETING THE CHECK LEDS
- When the energizer is in normal working order, the central green LED of the energizer lights up at each pulse.
- If the left-hand blue LED is on, then the fencing has significant parallel losses. This means that there is probably a large amount of
vegetation growth in contact with the fencing and/or faulty insulators, or that you are testing the quality of the basic earth rod connection
according to the procedure described above). You should plan to clear around the fencing and check the installation in the near future.
- If the blue LED is on and the green LED is off, then the parallel loss on the fencing is much too large. This means that there is too much
vegetation in contact with the fencing and/or the faulty insulators. You must absolutely clear around the fencing and check the installation.
- If the red LED on the right switches on (only if a reference earth rod has been installed), the earth rod quality needs to be improved
according to the steps detailed in paragraph 5 above.
CAUTION : Once the plug is connected to the mains supply, the central green LED that indicates correct operation must light up
approximately 50 times per minute.
V
BAR GRAPH :
max
- This shows the state of the general voltage in the energizer terminals.
Delayed effect fence energizer.
DELAYED EFFECT :
- For your safety, the device adapts its output energy to a charge change after 25 seconds.
- The device can also enter safety mode. When there is a sudden and considerable increase in charge to the fence, the
unit emits a noise, the warning light flashes, and the frequency and the output energy are decreased.
Safety mode lasts for 12 minutes.
During this time, the device continues to supply enough energy to contain the animals.
The digital display alternates between 2 screens.
1st screen :
2nd screen :
Example of an average
amount of vegetation
Empty
- When the energizer is in safety mode or delayed effect (see above information), the symbol
UBI 15 000 / V150 - MEANING OF DISPLAY :
x,x joules
x,x volts
VEGETATION
VEGETATION
(a)
(b)
(c)
Output power
Output Voltage
Indicates the amount of vegetation on the whole fence.
Lots of vegetation
9
VEGETATION
will be displayed.