General Description; Safety Instructions - Videor eneo VKC-1331A Instrucciones De Manejo

Installation / Operating Manual
1/3" Colour Cylindric Camera
VKC-1331A

1. Safety Instructions

• Read these safety instructions and the operation manual first before you install
and commission the camera.
• Keep the manual in a safe place for later reference.
• P rotect your camera from contamination with water and humidity to prevent it
from permanent damage. Never switch the camera on when it gets wet.
Have it checked at an authorized service center in this case.
• Never operate the camera outside of the specifications as this may prevent the
camera functioning.
• Do not operate the cameras beyond their specified temperature, humidity or
power ratings. Operate the camera only at a temperature range of -10°C to +50°C
and at a humidity of max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug.
Never pull the cord itself.
• P ay attention when laying the connection cable and observe that the cable is not
subject to heavy loads, kinks, or damage and no moisture can get in.
• Do not attempt to disassemble the camera board from the housing.
• The warranty becomes void if repairs are undertaken by unauthorized persons.
Do not open the camera housing.
• Never point the camera towards the sun with the aperture open.
This can destroy the sensor.
• Installation, maintenance and repair have to be carried out only by authorized
service centers. Before opening the cover disconnect the unit from mains input.
• The fitter is responsible for the system of protection being followed in accor-
dance with the technical data, e.g. by sealing of the cable outlet with silicone.
• Contact your local dealer in case of malfunction.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• Do not use strong or abrasive detergents when cleaning the dome.
Use a dry cloth to clean the dome surface.
In case the dirt is hard to remove, use a mild detergent and wipe gently.
• During assembly, care must be taken to ensure that existing seals are
correctly inserted and are not displaced as a result of assembly.
You must not continue to use damaged seals.
NOTE: This is a class A digital device. This digital device can cause harmful
interference in a residential area; in this case the user may be required
to take appropriate corrective action at his/her own expense.

2. General Description

• Cylindric Colour CCD Camera
• 1/3" Sony Super HAD II CCD Imager
• Sensitivity of 0.2 Lux (F1.2)
• Automatic Shutter Control (ESC)
• Automatic Gain Control (AGC)
• Automatic White Balance (AWB)
• Supply Voltage: 12VDC
• Weatherproof Aluminium Housing (IP67)
• Mounting Stand with Swivel Head
• Compact Version (19mm Outside Diameter)
3. Mounting
4. Connections
BNC Female
DC Male
Cable connection
CAUTION
• A regulated 12VDC 300mA power supply is recommended for use with this
camera for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera.
When unregulated power supply is applied, product warranty will be out of
subject.
• It is recommended that the camera is used with a monitor that has a
CCTV quality 75 video impedance level. If your monitor is switched to high
impedance then please adjust accordingly.
TV Monitor
Video IN
12V regulated
power supply