Gibson Cerwin-Vega CVM-1022 Manual Del Usuario página 10

Mesa de mezclas profesional
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FRONT PANEL CONTROLS – INPUT/OUTPUT CONNECTORS (continued)
(7). SEND JACKS
* AUX: These are unbalanced phone jacks-type output jack. This jack output the signal form AUX bus, respectively. You
use this jack, for example, to connect to an effector or to a cue box or other such monitoring system.
* EFX: These are unbalanced phone jacks-type output jack that output the signal form the EFFECT bus. You use this jack,
for example, to connect to an external effector
(8). RETURN L (MONO), R Jack
These are unbalanced 1/4" phone-type line input jacks. The signal received by these jacks is sent to the MAIN bus and
AUX bus. These jacks are typically used to receive a return signal from an external effect (reverb, delay, etc.)
NOTE: These jacks can also be used as an auxiliary stereo input. If you connect to the L (MONO) jack only, the mixer
will recognize the signal as monaural and will propagate the identical signal on both L and R jacks
(9). MAIN L/R OUTPUT JACKS
These jacks deliver stereo output of the mixer signal. You use these jacks, for example, to connect to the power
amplifiers driving your main speakers. You also use these jacks when you wish to record the signal utilizing the level
control applied by the main volume in the main Control section.
(10). CONTROL ROOM OUTPUT JACKS
Use these stereo phone-type output jacks to connect to your monitor system.
NOTE: The main output signals also route to these jacks controlled by the CTRL ROOM / PHONES volume.
(11). HEADPHONE JACK
Connect for headphones. This is stereo phone-type output jack (3-conductor TRS).
NOTE: The main output signals also route to these jacks controlled by the CTRL ROOM / PHONES volume.
10

Publicidad

Tabla de contenido
loading

Tabla de contenido