As10 Active Speakers - Cambridge Audio incognito Guia De Instalacion

ADVANCED SYSTEM OPTIONS
Speaker cable
AS10-A
LR10
Cat5
PS10
AS10-P
AH10
Incognito multi-room
AS10 A A ctive S S peakers
The AS10 active speakers can be used where it is not desired to
have a keypad fitted in the wall. The AS10 active speakers feature
an IR receiver and amplifier in one of the speakers and like the
KP10 keypad do not require mains power.
1. Using a single Cat-5e cable, connect the AS10-A to the
AH10/VH10 via an RJ45 plug at the AH10, and the eight-way
colour-coded punch down connection at the AS10-A.
The RJ45 hub connection should be wired to EIA/TIA568A
standard as shown in the wiring guide on page 6.
The Cat-5 connection from AH10 to the AS10-A should not
exceed 30m / 100 ft.
2. The AS10-A is then connected to the AS10-P using either Cat-5e
cable terminated at eight-way colour-coded punch down connec-
tions (all eight cores must be connected) or using a run of
standard speaker cable.
Only one method of connection between the active and passive
speaker is necessary.
Full details of installation, connection, operation and special features
can be found in the guide that accompanies the AS10 speakers.
Incognito multi-room 11