Cambridge Audio incognito Guia De Instalacion página 18

AS10 / SS10 in-c c eiling s s peakers
L-shaped probe used
to check available void
Standard installation would specify AS10/SS10 ceiling mounted
space before cutting
speakers which are matched to the Incognito system for optimum
speaker holes
audio performance. However, virtually any customer-specified
speaker units may be used.
Where ceiling or wall-mounted speakers are used, care should be
taken to ensure that all building regulations are followed.
When mounting speakers flush to a ceiling or wall, ensure that
enough depth/clearance is available in the respective cavity. A
clearance of at least 80 mm is necessary when mounting pairs of
AS10/SS10 speakers.
When deciding upon a ceiling or wall placement, care should be
taken to avoid joists, load bearing beams etc.
Before cutting ceiling loudspeaker holes it is suggested that the
area is tested for clearance by making an L- shaped probe from
strong wire (eg a coat hanger), drilling a small hole in the target area,
inserting the probe and slowly turning. Any obstructions will be
immediately obvious, so that the target area can be moved to a
more suitable position.
AS10/SS10
Also, locate loudspeakers taking into account location of furnishings
for optimal stereo reproduction.
207mm diameter
mounting hole
Full details of installation, connection, operation and special
features can be found in the guide that accompanies the speakers.
18 Incognito multi-room