After-Sales Service - Pujol twister Serie Instrucciones De Instalación Y Reglaje

V. WIRING DIAGRAM: (Fig. 4)
VI. LIMIT TRAVEL SETTING:
1. Customers can adjust and set the positions of top and down limits by themselves.
2.According to motor rotating direction and adjusting instructions, insert travel limit pole into its travel limit hole to adjust
limit travel: the direction of "+" is increas1ing shutter's travel; the direction of "-" is decreasing shutter's travel. (Fig. 5)
3. After setting limits, start shutter to go up-and-down, and check travel limit position suitable or not. If not, re-set them.
Trouble and solutions
Tr ouble
nº
Press the controller down
1.
button, the shutter moves
upward instead of downward
The driving adapter can
2.
only rotate in one direction
when the power is on
When power is switched
3. on, the motor refuses to
work or starts slowly
Sudden stop of the
4.
operating motor
The motor stops operation
and path length cannot be
5.
increased
6. Unexpected noise emitted
during shutter rolling
AFTER SALES SERVICE
OF
TERM GUARANTEE
PUJOL MUNTALÀ, S.A. guarantees its door actuators, electrical equipment and supplements against any manufacturing
failures for a period of 2 years from the date they are provided.
LIABILITIES
PUJOL MUNTALÀ, S.A. undertakes to repair equipment subject to guarantee, prior revision by our technical department. Any
equipment delivered due to urgency before it has been decided if it is under guarantee, will be considered as a standard
order to be paid.
Replaced faulty equipment under guarantee will remain property of PUJOL MUNTALÀ, S.A.
The installer will replace said equipment at his/her own cost.
Freight will be paid by PUJOL MUNTALÀ, S.A.
CANCELLATION
PUJOL MUNTALÀ, S.A. equipments will not be covered by the guarantee in the following cases:
-Incorrect election of equipment due to door features.
-Assembly and/or connection instructions have not been followed.
-The actuator or equipment is unpaid.
modelo
Possible reasons
Line connection opposite
The switch of the other
a. Voltage too low
b. Errors in line connecion
c. Overload
d. Instalation errors
Rated operating time
(4min) exceeded
The spacing has been
adjusted to the maximum
The tube too long, which
causes the tightness between
the rolling shutter and the
bracket in both
automatismos pujol 8
english
Solutions & suggestions
Exchange the connection head
between the brown and black
line
Rotate the crown toward the
rotating direction of the driving
adapter
a. Regulate the voltage to the rated
b. Chech the lines and correct it
c. Install the load revelant to the
rated torque
d. Reinstall the motor
After approximstely 20 minutes,
it will resume automatically
when the motor cools down
Remove the motor and rotate
the crown towards the inverse
direction several rounds (accor-
ding to the practical need).
Then put into the tube and
adjust to the ne cessary spacing
position
cut a little of the tube with a saw,
to loosen the tightness between
the bracket and roller shutters