Honeywell VisionPRO IAQ Guia De Instalacion página 2

VisionPRO ® IAQ Equipment Interface Module
Installation
1 Remove cover from Equipment Interface Module (EIM).
2 Select location and mount EIM as shown below.
Furnace/air handler
CAUTION: This product may be damaged if mounted inside HVAC equipment. Install
only on the outside of HVAC equipment.
Wiring
Connect wires as shown below (see wiring guides on following pages).
Water heater
All wiring must comply with local electrical
codes and ordinances.
2
Wall anchor
Mounting screw
Drill 3/16" holes
for drywall. Drill
7/32" holes for
plaster.