Prepare Your Distiller; Clean The Water Bottle; Sanitize The Water Bottle; Prepare The Carbon Filter - Nautilus W10120N Guía De Uso Y Cuidado

Cap
Filter
Dispensing
Valve
Water Bottle

PREPARE YOUR DISTILLER

Before using your distiller for the first time, please follow the steps below.

CLEAN THE WATER BOTTLE

First, make sure the dispensing valve is installed and tightened onto the water
bottle. Then fill the water bottle about
dish detergent to the water. Do not install the carbon filter at this time. Seal
the bottle's top opening with the cap supplied. Shake the bottle vigorously and
then drain. Rinse the bottle thoroughly to remove all of the detergent.
NOTE: Do not allow the soap/water mixture to remain in the water bottle for
long periods of time. Do not use the water bottle to store liquids other than
distilled water. Liquids other than distilled water may transfer a taste or odor to the
water bottle.
TO SANITIZE WATER BOTTLE
⁄
Add 4 3 ounces (150 ml) of 3% hydrogen peroxide solution (H
4
bottle. Fill the bottle with hot (160˚F/71˚C) distilled or tap water. Do not install
the carbon filter at this time. Cap the water bottle and shake the vigorously.
Let stand for twenty minutes then drain thoroughly. Rinse with room temperature
distilled or tap water, then drain. Water bottle may be used immediately or
allowed to air dry.

PREPARE THE CARBON FILTER

To prepare the carbon filter, place it in boiling water for five minutes. Drain
excess water from filter. Place the filter into the water bottle. The same cleaning
process should be used whenever a new replacement filter is installed. The
Boiling
Chamber
Cap
Baffle
Flat Gasket
Boiling Chamber
O-Ring
Securing
Nut
Distiller Chassis
⁄
3
full with water. Add one or two drops of
4
-4-
Cooling
Vents
Cord
O ) to the water
2 2