Proper Installation; Electrical Shock Hazard; Start-Up Sequence; When Not In Use - Hotpoint HTW200 Manual Del Propietario E Instalación

PROPER INSTALLATION

This washer must be properly installed and located in accordance with the Installation Instructions before it is used.
Ensure that the hot water hose is connected to the "H"
valve and the cold water hose is connected to the "C"
valve.
Install or store where it will not be exposed to
temperatures below freezing or exposed to the weather,
which could cause permanent damage and invalidate the
warranty.
Properly ground washer to conform with all
governing codes and ordinances. Follow details
in Installation Instructions.
WARNING
Plug into a grounded 3 prong outlet.
DO NOT remove ground prong.
DO NOT use an adapter.
DO NOT use an extension cord.
Failure to follow these instructions can result in death
or electrical shock.
Ensure washer is properly leveled and washer legs are
adjusted such that unit is stable.

START-UP SEQUENCE

Any time the washer is being started or restarts after the
washer lid has been opened and closed, the washer will
turn on the cold water valve for two short periods followed
by a 10 second pause before continuing.

WHEN NOT IN USE

Turn off water faucets to minimize leakage if a break or
rupture should occur. Check the condition of the fill hoses;
GE recommends changing the hoses every 5 years.

- Electrical Shock Hazard

Optional drain hose extension recommended for
discharging heights from 60" - 96".
This washer does not include water supply hoses.
GE Appliances strongly recommends the use of factory
specified parts. A list of factory hoses available for
purchase are listed. These hoses are manufactured and
tested to meet GE Appliances specifications.
GE Appliances strongly recommends the use of new water
supply hoses. Hoses degrade over time and need to be
replaced every 5 years to reduce the risk of hose failures
and water damage.
Parts and Accessories
Order on-line at GEApplianceparts.com today, 24 hours a
day or by phone at 800.626.2002 during normal business
hours.
Part Number Accessory
PM14X10002 4 ft rubber water supply hoses
Or
PM14X10005 4 ft braided water supply hoses
WH49X301 Drain hose extension
PM7X1 Washer Floor Tray
If the lid is opened during this period, the washer will
pause. You will have to push the Start button again to
restart the cycle.
SAVE THESE INSTRUCTIONS
www.Hotpoint.com
3