Warnings And Cautions - D-Link DSN-4000 Serie Guía De Instalación Rápida

9. Configure the Storage System
To configure the DSN-4100/DSN-4200 storage system after the first-time startup, wait for the unit to reboot
(up to five minutes, and the Global Enclosure Status LED illuminates solid green), then start your Web
browser to match the IP address identified in step 8E above (default is 192.168.1.1).
When the browser connects and the GUI is operational, the Login Screen appears and you are ready
to connect to the iSCSI world. Enter your Administrative username and password, then select System
Administration from the View Panel, select the Settings tab, and select System Policy to ensure that the
proper battery policy is defined for your environment.
Refer to the xStack Storage Software User's Guide on the Product CD for the next steps to configure
and begin using iSCSI storage with the DSN-4100/DSN-4200 storage system.

10. Warnings and Cautions

This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to adequate measures. There is a risk of explosion if the battery is replaced
by the incorrect type. Dispose of used batteries according to the instructions that accompany the battery.
This product supports disk drive hot-swapping. To avoid hand contact with an electrical hazard, do not
remove more than one drive carrier at a time.
6
D-Link DSN-4000_Series Quick Installation Guide