Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC SHREDDING OPERATION
Continuous operation: 10 minutes maximum
NOTE: Shredder runs briefly after each pass
to clear entry. Continuous operation beyond 10
minutes will trigger 20-minute cool down period.
JAM BLOCKER SYSTEM OPERATION
Blocks jams before they start.
1
2
If Remove Paper icon ( )
Reduce paper quantity
is illuminated, there is too
to an acceptable
much paper for the shredder
amount and refeed
to power through
into paper entry
SAFESENSE
®
TECHNOLOGY OPERATION
SET-UP AND TESTING
1
2
Press Auto On (
)
Touch test area and
look for the SafeSense
indicator to illuminate
BASIC PRODUCT MAINTENANCE AND TROUBLESHOOTING
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished sheet
capacity, intrusive noise when shredding and could ultimately
stop running. To avoid these problems, we recommend you
oil your shredder each time you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
PAPER/CARD
1
Plug in and put
disconnect power
switch in ON (I) position
www.fellowes.com features an extensive on-line support section with a number of self-service options
3
Paper jam: Shredder will
automatically reverse the
paper out for easy removal
3
4
SafeSense
is active and
If hand is held on SafeSense
®
working properly
area more than 2 minutes
®
shredder will shut off
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off
2
3
Feed paper/card
Press Auto On (
)
to activate
straight into paper
entry and release
Indicator lights:
®
2
3
Press and hold Reverse
*Apply oil across entry
(
) 2-3 seconds
4
When finished
shredding set
to OFF
Wait 20 minutes for motor to cool down
Make sure bin is pushed in
Remove paper
Yellow - SafeSense
®
active
3
Publicidad
Tabla de contenido
