Propane/Lp Safety; Assembly Instructions - Desa Outdoor Leisure SPC-54PHW El Manual Del Propietario

SaFETy InFOrMaTIOn
Continued
24. Keep heater away from areas where flam-
mable liquids, vapors or solids are stored
or used.
25. If operated in salt air environments, the
unit will require more frequent cleaning;
otherwise, the longevity of the unit will
deteriorate rapidly. Use warm soapy water
to clean the unit.
26. Items or material, when stored under the
heater, will be subjected to radiant heat
and could be seriously damaged.
Any guard or other protective device
removed for servicing must be re-
placed prior to operating the heater.
Surface temperatures become very
hot when operating heater. Children
and adults should stay away to avoid
burns or clothing ignition.
Young children should be carefully
supervised when they are in the area
of the heater.
Clothing or other flammable mate-
rials should not be hung from the
heater, or placed on or near heater.
Installation and repair should be
done by a qualified service person.
The heater should be inspected
before use and at least annually by
a qualified service person. More
frequent cleaning may be required
as necessary. It is imperative that
control compartments, burners and
circulating air passageways of the
heater be kept clean.
CAUTION: The gas pressure
regulator provided with this ap-
pliance must be used. This regu-
lator is set for an output pressure
of 11" W.C. (2.74 kPa).
4

PrOPanE/LP SaFETy

only.
ASPhYxIATION hAzARd
• do not use this heater for heating human
living quarters.
• do not use in unventilated areas.
• The flow of combustion and ventilation
air must not be obstructed.
• Proper ventilation air must be provided
to support the combustion air require-
ments of the heater being used.
• Refer to the Specifications, page 2, heat-
er data plate or contact dESA heating
Products to determine combustion air
ventilation requirements of the heater.
• Lack of proper ventilation air will lead
to improper combustion.
• Improper combustion can lead to carbon
monoxide poisoning leading to serious
injury or death. Symptom of carbon mon-
oxide poisoning can include headaches
dizziness and difficulty in breathing.

aSSEMBLy InSTruCTIOnS

Tools Required:
• # Phillips Head Screwdriver 1
• Adjustable Wrench
Inspect heater components for possible ship-
ping damage. If any is found, immediately
notify the dealer. Check to make sure that all
components are included with your heater
(see pages 10 and 11).
POLE ASSEMbLY
1. Attach legs to base using two bolts, two
lock washers and two nuts (see Figure 1,
page 5). Insert bolts through legs and into
top of base. Attach lock washers and nuts
from underneath base. Finger tighten only.
Repeat for each leg. Do not fully tighten
until next step.
. Secure pole support to legs using two
bolts, two lock washers and two nuts.
Repeat for each leg. Wrench tighten nuts
and bolts from step 1 and .
3. Attach ballast weight to base using one,
long bolt, lock washer and nut (see Figure
1, page 5).
www.desatech.com
WARNING: For outdoor use
2
114144-01J