EN
H
ow to replaCe a damaged Handle
Carefully detach the cable on the side of the dental water jet so as not to damage the outlet
fitting.
Replace the handle with a new one, carefully inserting the cable into the outlet fitting.
EXTRAORDINARY MAINTENANCE – REPLACEMENT OF THE OZONE PRODUCER
The production of ozone lasts approximately 3 years (it may vary depending on number of
use cycles). In this case, the device will alert you to the need for "Extraordinary Maintenance"
through the sequential flashing of the LEDs. The device must be sent back to Customer Service
so that the Ozone Producer can be replaced. It is not possible to independently reset the
"Extraordinary Maintenance" alarm and the device will be able to work again only after the
Ozone Producer has been replaced.
IMPORTANT
•
Always remember to empty the hydraulic circuit before any transport
storage of the device.
•
If the device is going to be returned for extraordinary maintenance, remove the
interchangeable nozzles before returning.
•
When requesting a replacement handle, be very careful not to damage the outlet fitting
when removing the old handle.
•
These are fundamental requirements. Non-compliant returns may be refused.
DISPOSAL
Pay particular attention to the regulations on waste sorting and disposal currently in force.
The water jet device must not be thrown away as household waste, but has to be handed over
at authorized municipal landfills.
The external and replaceable parts of the water jet, such as nozzles and handle, can be recycled
normally.
TECHNICAL SPECIFICATIONS
Manufacturer
Model
Voltage supply
Class
Applied part
Weight
Dimensions
Usage temperature
Intermittent operation
Transport temperature
EB2C srl - Via Savona, 94 - 20144
Milan - Italy
Aquolab Basic
100-240 V 50/60 Hz 36 W
II
Handle (type B)
0.99 Kg
190 mm x 140 mm x h150 mm
+5°C ÷ +40°C
3 min ON / 1 min OFF
-25°C ÷ +50°C
EXPLANATION OF LABELLING SYMBOLS
It is obligatory to read this user's manual
Selective waste sorting is obligatory
Do not reuse (disposable device – just for some handles)
IP21
Protected against access with a finger to dangerous voltage parts
Protected against the entry of vertical water drops
or long-term
Type B applied part
CE marking