Control Pod
Camlock
Search Coil
Connector
Handgrip
6. Thread the velcro arm strap through the slots on the armcup. With
your arm in position, fold the strap over onto the velcro so that the
strap is loose enough to to pull your arm in and out of the armcup.
7. Grip the detector and sweep the search coil over the floor. If the fit feels
uncomfortable, adjust the position of the lower fiber rod. The ideal
position allows you to stand up straight and sweep the search coil over
the ground without stooping over.
8. Install eight "AA" batteries in the battery holder carefully noting the +
& - positions marked inside the battery holder. Insert the battery pack,
lining up the contacts. Tighten the battery seal.
Display
Control Buttons
Velcro Armstrap
Battery Holder with Cap
3