Installation; General Advice - Vestfrost CVKS 611 Instrucciones Para El Uso

Installation

See drawings - page A and B.
Install the cabinet in a dry place and so that
it is not exposed to direct sunlight or any
other sour ce of heat.
Place the cabinet in a level position. This is
easily achieved by adjusting the adjustable
feet at the front edge of the base.
The cabinet may not rest against a wall on
its hinged side. When placing the cabinet
on a carpet or on a wooden floor you should
adjust it once more after some time as the
cabinet might settle in soft foundati ons.
If you want to build the appliance into a
cupboard you must consider 3 factors:
1. There must be space above the appli-
ance in order to make the cooling system
work satisfactorily.
2. When the door is opened the appliance
takes up more room in the width and
therefore the door must either be placed
outside the cupboard or there must be
a space of at least 1,5 cm at the hinge
side.
3. The distance to the wall at the hinge side
must be of a sufficient size.
.
Furthermore it is possible to build together
two appliance. If one of these is a wine
cabinet please observe a min. distance of
25mm between the cabinet in order to keep
cooling performance intact.
It is safest to place the earthed wall socket
abo ve the appliance and at least 2.0 m
above the floor. Any local installation rules
for appliances of this kind must be ob-
served.
Max. 36 kg
Max. 85 kg.

General advice

If the unit is not used for more than two
days it should be switched off and the doors
should be left open for ventilation to prevent
a bad smell in the unit.
The appliance is equipped with a high
quality skin condenser. Therefore, a slight
heating of the sidewalls is quite normal
Lighting
This appliance is equipped with a device
which causes the light to switch off if the
door is open / left on for abnormally long
time.
When the door has been closed for a cou-
ple of minutes, the device is cut off and the
light switches back on.
7
GB