Pattern List - JB Systems SMOOTH SCAN-BLUE LASER Manual De Instrucciones

ENGLISH

Pattern list

JB SYSTEMS 11/62
®
USER MANUAL
SMOOTH SCAN-BLUE LASER
ENGLISH
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
 Clean the external optics at least once every 30 days.
 Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input: AC 100~240V, 50/60Hz
Fuse: 250V 1A slow blow (20mm glass)
Total Power consumption: 13W
Sound Control: Internal microphone
DMX connections: 3pin XLR male / female
DMX channels: 1 or 17 channels
DMX starting address: 001  512
Laser Power: 400mW Blue CW laser (λ = 450nm)
Laser radiation class: 3B
Beam diameter @ aperture: <5mm
Divergence (each beam) <12 mrad
Divergence (total output) <90°
Scanner speed: 15kHz
Working temperature: 10°C to 40°C
Laser Safety Standard: EN/IEC 60825-1 Ed2, 2007-03
Size: see picture below
Weight: 1.5kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
JB SYSTEMS 12/62
®
USER MANUAL
SMOOTH SCAN-BLUE LASER