Correct Use Of The Product - POLTI Forzaspira AG100 Instrucciones Para El Uso

CORRECT USE OF THE PRODUCT

This appliance is intended for home use for
cleaning damp, smooth surfaces such as win-
dows, mirrors or tiles, in accordance with the in-
structions provided in this manual. Please read
these instructions carefully and keep them for
future reference.
Polti declines liability for any damage or
accident derived from any use of this ap-
pliance which does not comply with the in-
structions contained in this booklet.
ATTENTION
Directive 2002/96/EC (Waste Electrical and
Electronic Equipment - WEEE): information
for users
This product complies with EU Directive
2002/96/EC.
The crossed-out wastebasket sym-
bol on the appliance means that at
the end of its useful lifespan, the pro-
duct must be disposed of separately
from ordinary household wastes.
The user is responsible for delivering the ap-
pliance to an appropriate collection facility at
the end of its useful lifespan.
Appropriate separate collection to permit
recycling, treatment and environmentally
compatible disposal helps prevent negative
impact on the environment and human health
and promotes recycling of the materials
making up the product. For more information
on available collection facilities, contact your
local waste collection service or the shop
where you bought this appliance.
UNPACKING
♦ Remove the appliance from the packaging,
checking that the product is whole and that
all the parts are there.
FORZASPIRA AG100 - AG130
The appliance is not supplied with the battery
charged, therefore please charge the product
before use.
To charge the appliance, proceed as follows:
♦ Connect the power supply plug (J) to the
special socket (F) of the appliance.
♦ Insert the power supply plug (J) to a suita-
ble power socket.
♦ The charging / operating LED (D) will start
flashing red. When the LED (D) turns a
steady green (after about 2 1/2 hours), the
appliance is charged and ready for use.
Note:
- When the battery is discharged, the ap-
pliance will stop working and the LED (D)
will be off.
- A full battery recharge makes it possible to
clean up to 80 m2 of surface.
ASSEMBLY
♦ Unscrew the sprayer (L1) from the bottle
(L2).
♦ Insert the washing support (N) into the
sprayer (L1) and lock it with the fastening
ring (M) (Fig. 7 - 8 - 9).
♦ Insert the cloth (K) and lock it with the Vel-
cro (Fig. 10).
FILLING
♦ Fill the bottle (L2) with water and possibly
non-foaming glass detergent that is com-
monly available on the market.
♦ Tighten the sprayer (L1) including the wa-
shing support with the cloth, to the bottle.
USE
♦ Spray the surface to be cleaned and
cleanse with the cloth.
♦ Run the appliance over the area as shown
in the Chapter "Use".
(*) Only for Model AG130.
14
CHARGING APPLIANCE
VAPORISER (L) (*)