IR remote control PIR 3
Battery safety instructions
DANGER! Batteries can be swallowed.
This can lead directly to death by suffoca-
tion. Dangerous substances can cause
severe internal burns leading to death
within 2 hours.
Keep new and used batteries away from
children.
Do not use any equipment on which the
battery compartment cannot be closed
reliably or keep it away from children.
If you suspect that a battery has been
swallowed or is in any orifice of the body,
seek medical attention immediately.
WARNING! Improper handling of batteries
may result in an explosion, fire or burns
due to leakage.
Do not heat batteries or throw batteries
into fires.
Do not reverse the polarity, short-circuit or
recharge batteries.
Do not deform or disassemble batteries.
Only replace batteries with the same or
equivalent type.
Remove flat batteries immediately and dis-
pose of them in an environmentally sound
manner.
Intended use
- Infrared remote control for manual opera-
tion and setting of motion detectors.
20
Operation
Tabelle 1: IR remote control function
buttons
Button
Function
Auto
Automatic mode
ON
Continuously On for
2 hours
OFF
Continuously Off for
2 hours
Mas./
no function
Slave
no function
25 %,
Setting the detection sensi-
50 %,
tivity
75 %,
100 %
- 5 %
Fine adjustment of detec-
tion sensitivity in 5 % dec-
rements until minimum
range is reached
+ 5 %
Fine adjustment of detec-
tion sensitivity in 5 % incre-
ments until maximum
range is reached
1 sec
Short-term operation
30 sec
Delay time 30 seconds
2 min
Delay time 2 minutes
5 min
Delay time 5 minutes
30 min
Delay time 30 minutes
START
/
Set individual delay time,
STOP
max. 60 minutes
Night mode switch-on
threshold approx. 2 lx
Switch-on threshold
approx. 10 lx
Switch-on threshold
approx. 150 lx