Pepperl+Fuchs DA5-IU-C Manual De Instrucciones página 15

DA5-IU-C
4.6 Maximum input signal
This menu item allows exten-
ding or reducing the measu-
ring range.
If the input signal exceeds the value program-
med here for the measuring range
4 ... 20 mA, max. 20.5 mA, default 20 mA
0 ... 20 mA, max. 20.5 mA, default 20 mA
2 ... 10 V, max. 10.5 V, default 10 V
0 ... 10 V, max. 10.5 V, default 10 V
is displayed.
The display alternates between "hi" and the
measured value. Above the max. program-
mable measuring range, 9.9.9.9.9 is displayed
to signal an overflow. In case of an input
voltage >10.8V there is an error, the message
Error4 is displayed.
4.7 Display value for the highest input
signal
The highest input signal
(10V, 20mA) can be assi-
gned a displayed value bet-
ween -19999 and 99999. The
decimal point setting is taken
into consideration (e.g. range
0 ... 10V, this programmed
value is issued for 10V).
4.8 Minimum value display
Acquisition only within the
measuring range set under
4.1, 4.4
Minimum value is displayed
The minimum value display
is ignored and the next menu
title is skipped
4.9 Minimum value reset
Manual reset (with red key)
and electrical reset. When
activated, the RESET input
and the RESET key reset the
minimum value to the current
measured value.
No reset of the minimum
value possible.
Electrical reset only.
When activated, the RESET
input resets the minimum
value to the current measu-
red value.
Manual reset only. When
activated, the RESET key
resets the minimum value to
the current measured value.
4.10 Maximum value display
Acquisition only within the
measuring range set under
4.1, 4.6
Maximum value is displayed
The maximum value display
is ignored and the next menu
title is skipped
4.11 Maximum value reset
Manual reset (with red key)
and electrical reset. When
activated, the RESET input
and the RESET key reset the
maximum value to the cur-
rent measured value.
No reset of the maximum
value possible.
Page 5 (R60046.9398 - Index 1)