Hapro Luxura X5 Modo De Empleo página 8

+
Config. Increase body cooling
Decrease body cooling Increase body cooling
Start
A
Start
B
Stop
The default settings for the sun bed are for use with an external timer or for coin-operated use. If the
sun bed is used without an external timer or not coin-operated, and the internal timer needs to function,
the required tanning time should be set following the procedure described below.
General
Keep the "config" and the "increase body cooling" buttons pressed simultaneously for 10 seconds.
After 10 seconds, the display will show "SET 20".
Pressing the "increase body cooling" button means the tanning time can be increased (max. 30 minutes)
Pressing the "decrease body cooling" button means the tanning time can be decreased.
Pressing the "start" button will confirm the setting.
If the controls have been set for use with an external timer or coin-operated use, the display will show an "A" after confirmation.
If the controls have been set for use with an internal timer, the display will show an "H" after confirmation.
Note:
a. If it is necessary to cancel the configuration, please press the "stop" button.
b. If no settings are entered for a time span of 30 seconds, the controls will be reset to their original state.
c. A = automatic, H = manual
d. When an external timer is used or for coin-operated use, the tanning time must be set to 0 minutes.
Controls in combination with an external timer or for coin-operated use:
The sun bed will be started automatically if the external timer or coin-operated equipment does not have a "remote start". If
there is a "remote start", the sun bed must be started by pressing the "start" button.
Note:
If the sun bed has an external timer or is coin-operated and does not have a "remote start" function, but should be started by
using the "start" button, your dealer will be able to set this for you.
The equipment will pause when the "stop" button is pressed once. If stop is pressed more than once, the equipment will remain
paused. The sun bed will not stop until the tanning time is up.
Note:
A. If the sun bed is restarted within 3 minutes after stop has been pressed, it is possible that the face tanners do not switch on.
These need to cool down for at least 3 minutes, after which they will switch on again automatically.
B. If the "stop" button is pressed, the airco will switch off after a 5 minute delay. Following these 5 minutes, the airco also has a
cooling down period of 3 minutes.
C. The tanning time will count up.
Controls
8