Casals Rapidissimo clean Manual Del Usuario página 11

Take great care when removing them.
- Only use the measuring beaker to fill the water
tank.
- To protect against the risk of electrical shock, do
not immerse the steam cleaner / fabric steamer
in water or other liquids, or handle it with wet
hands.
- Never tug on the power cord to disconnect it
from the power outlet. Hold the plug and pull it
out to disconnect it.
- Make sure that the cable does not come into
contact with hot surfaces. Allow the steam
cleaner / fabric steamer to cool down completely
before storing it.
- Disconnect the appliance when it is not in use.
- Do not operate the steam cleaner/fabric stea-
mer if the cable is damaged or if the appliance
has been dropped or is damaged. To avoid the
risk of electric shock, do not disassemble the
product. Contact a qualified service centre for
inspection and/or repair Incorrect assembly of
the cleaner may cause a risk of electric shock.
- Always monitor any equipment used near
children when the steam cleaner is used. Do not
leave the steam cleaner/fabric steamer unatten-
ded when switched on.
- Do not allow children to use this device.
- Touching the hot parts, the hot water or the
steam that the cleaner generates may cause
burns. Always be cautious when there is hot
water in the tank.
- This product is designed for domestic use only,
not for commercial use.
FILLING THE TANK WHILE USING THE CLEA-
NER
- Make sure that the appliance is unplugged.
- Unscrew the safety cap (3), fit the funnel in the
tank hole and fill it with 1 measure of the beaker
(6) (Fig. A). Remember that the water should
not go above the mark on the beaker.
- Unscrew the safety cap (3).
- Plug in the steam cleaner and wait for the pilot
light to go off, telling you that the appliance is
ready for use.
- IMPORTANT NOTE: Never refill the water tank
when the appliance is plugged into the wall
outlet.
USER INSTRUCTIONS
- Connect the required cleaning attachment and
plug in the appliance.
- The pilot light (5) will come on indicating that the
appliance is plugged in.
- When the steam cleaner has the pressure requi-
red to operate, the pilot light (5) will go off indi-
cating that you can start to use it. This operation
will take approximately 5 minutes. During use,
the warning light will go off and then come on,
indicating that the steam cleaner is recovering
the necessary pressure.
- We recommend pressing the control (2) repea-
tedly for short bursts rather than just a few times
for longer periods, so as to maintain pressure in
the reservoir.
- When finished using the steam cleaner, set the
on/off switch to the off position and disconnect
the device from the mains, wait for it to cool
down to remove the attachments.
ATTACHMENTS
TAPER NOZZLE (10)
- Insert the taper nozzle (10) in the mouth (4) by
lining up the lugs on the taper nozzle with the
holes in the mouth (4) and turn it clockwise as
far as it will go (Fig. B).
ROUND BRUSH (8) AND ANGLE NOZZLE (9)
- Fit these accessories in the taper nozzle (10) or
flexible hose (14) (Fig. D and E).
FLEXIBLE HOSE (14)
- If you want to reach inaccessible places or
the area to be cleaned is too far away, use the
flexible hose.
- Fit the hose on the appliance as explained for
fitting the taper nozzle (10).
- Fit any of the accessories accompanying the
appliance to the hose, from the flat side.
WINDOW AND FABRIC CLEANING ACCES-
SORIES (11-12)
- Use these accessories for cleaning floors, win-
dows, furniture, sofas, fabrics, and so on.
- The cloth (13) can be used for cleaning such
delicate surfaces as sofas and armchairs.
STEAM FLOW CONTROL:
- The appliance has a (2) control knob that allows
to get the control of the steam flow.