Thermal Protector - Kenmore 116.10065 Manual De Uso Y Cuidado

PERFORMANCE FEATURES
WARNING
Personal injury Hazard
Always turn off and unplug the vacuum
cleaner before cleaning the agitator area
as agitator may suddenly restart. Failure
to do so can result in personal injury.
THERMAL PROTECTOR
This vacuum cleaner has a thermal
protector which automatically trips to
protect the vacuum cleaner from
overheating, if a clog prevents the normal
flow of air to the motor, the thermal
protector turns the motor off
automatically. This allows the motor to
cool in order to prevent possible damage
to the vacuum cleaner.
To correct problem: Turn the vacuum
cleaner off and unplug the power cord
from the outlet to allow the vacuum
cleaner to cool and the thermat protector
to reset. Check for and remove clogs, if
necessary. Also check and replace any
clogged filters. Wait approximately fifty
(50) minutes and plug the vacuum
cleaner in and turn back on to see if the
motor protector has reset.
OVERLOAD PROTECTOR
The multi-surface nozzle has an overload
protector which automatically trips and
shuts off the nozzle motor. To reset, turn off
the vacuum cleaner. Wait approximately 5-
10 seconds and turn vacuum cleaner back
on.
MOTOR PROTECTOR
This vacuum cleaner
also has a motor Protector
protector by-pass
valve which prevents
motor overheating Cup
and damage, The
valve opens to
provide cooling air
when a clog prevents
normal air flow to the
vacuum cleaner
suction motor, You
will notice a change of sound as air rushes
through the valve opening.
To correct problem: Empty the dust cup and
clean the primary filter and pre-filter. Check
for and remove clogs, and empty dust cup if
necessary. See CLOG REMOVAL (page 16).
NOTE: Do not block motor protector.
NOTE: The motor protector may open when
using attachments due to reduced airflow
caused by the attachments.
EDGE CLEANING
The edge cleaning
system is designed
to help clean all
the way up to the
baseboards. The
suction shutter is
opened up when
the multi-surface
nozzle is pushed
against the wall.
Suction
SUCTION CONTROL
The suction control allows you to change the
vacuum suction for different fabrics and
floor surfaces.
Opening the
control decreases
suction for
draperies and
lightweight rugs,
while closing the
control increases
suction for
upholsteries and
other floor
surfaces.
Suction
= 14=