Performance Features; Thermal Protector; Suction Control - Kenmore 125.10701610 Manual De Uso

HOSE STAND
The vacuum cleaner can be stored with the
floor nozzle, wand and hose still connected.
NOTE: The wand must be collapsed to the
shortest length for hose stand storage.
WARNING
Personal Injury and Product Damage
Hazard
DO NOT carry the vacuum cleaner while
it is in the storage position. Injury or
damage may result if the hose or
telescoping wand becomes unattached.
1. Stand the vacuum
cleaner up, align the
arrows on the wand
and turbine unit, and
insert the wand
holder into the
wand holder slot on
the underside of the
canister body.
Hold Here
Wind

PERFORMANCE FEATURES

Wand
Holder Slot
2. Hold the hose
and wind it
around the
wand.

THERMAL PROTECTOR

This vacuum cleaner has a thermal
protector which automatically trips to
protect the vacuum cleaner from
overheating. If a clog prevents the normal
flow of air to the motor, the thermal
protector turns the motor off
automatically. This allows the motor to
cool in order to prevent possible damage
to the vacuum cleaner.
To correct problem: Turn off and unplug
vacuum cleaner to allow the vacuum
cleaner to cool and the thermal protector
to reset. Check for and remove clogs, if
necessary. See REMOVING CLOGS (page
12). Also check and replace any clogged
filters. Wait approximately fifty (50)
minutes and plug the vacuum cleaner in
and turn back on to check if the thermal
protector has reset.

SUCTION CONTROL

The turbine unit suction control allows for
adjustment of the force required to
push/pull the floor brush.
• Opening control decreases suction.
• Closing control increases suction.
- 11 -