On/Off Switch - BLACK&DECKER BDV212F Manual De Instrucciones

ENGLISH
but the temperature will eventually rise to that of the
surrounding air.
Observe hygiene rules common to any food preparation
appliance. Do not eat or drink perishable items that may
have spoiled or become contaminated.
Clean the appliance thoroughly after use and before
subsequent uses.
Features
This appliance includes some or all of the following features:
1. Low vehicle battery LED indicator
2. Hot LED indicator
3. Cold LED indicator

4. On/off switch

5. Padded top
6. Storage pouch
7. Built-in heat dissipation fan
8. Vehicle dc power cord
USE
Connecting to a portable 12 Vdc power supply, for use away
from the vehicle (fig.A)
Move the COLD/OFF/HOT switch (4) to the OFF position.
Insert the 12 Vdc plug on the power cord (8) into the 12 Vdc
socket on the portable power supply.
Note: Keep the COLD/OFF/HOT switch (4) in OFF position for
five minutes before switching between HOT and COLD.
Using the appliance as a cooler
Move the COLD/OFF/HOT switch (4) to the OFF position.
Start the vehicle or turn the ignition switch to the
"accessory" position.
Insert the 12 Vdc plug on the power cord (8) into the
vehicle's 12 Vdc accessory outlet.
Move the COLD/OFF/HOT switch (4) to the COLD position.
The COLD LED indicator (3) will light to show that the unit
is cooling.
Place items into the cooler and close the lid. Do not overfill
the cooler, make sure that the lid can close.
Keep the cooler lid closed during use and close it quickly
after adding or removing items.
After use, move the COLD/OFF/HOT switch (4) to the OFF
position and remove all food items.
Disconnect the vehicle dc power cord (8) from the vehicle's
accessory outlet.
Clean the unit as described in the Maintenance section.
Using the appliance as a warmer (fig. A)
Move the COLD/OFF/HOT switch (4) to the OFF position.
Start the vehicle, or turn the ignition switch to the
"accessory" position.
4
Insert the 12 Vdc plug on the power cord (8) into the
vehicle's 12 Vdc accessory outlet.
Move the COLD/OFF/HOT switch (4) to the HOT position.
The HOT LED indicator (2) will light to show that the unit is
warming.
Put items into the warmer and close the lid. Do not overfill
the warmer. Make sure that the lid can close.
The unit's warming system is thermostatically controlled.
Keep the warmer lid closed during use, and close it quickly
after adding or removing items.
After use, move the COLD/OFF/HOT switch (4) to the OFF
position and remove all food items.
Disconnect the vehicle dc power cord (8) from the vehicle's
accessory outlet.
Clean the unit as described in the Maintenance section.
To change this appliance to a freezer (fig B)
Fill the sealable ice tray (9) (included) a quarter full with
water. Fit the lid and place the tray at the bottom of the
cooler.
Place the freezer insulation pad (10) (included) on top of the
sealed ice tray to convert the cooler to a freezer.
Hints for optimum use
The warmer takes about 100-120 minutes to reach its
maximum warm temperature (approx. 48 ºC). It is
recommended that items to be stored in the warmer be pre-
heated. This will assist the warmer in reaching the maximum
temperature as quickly as possible.
The cooler takes about 120-200 minutes to reach its
maximum cool temperature (approximately 27 ºC below that
of surrounding air). It is recommended that items to be
placed in the cooler be pre-chilled. This will assist the cooler
in reaching the lowest temperature as quickly as possible.
The travel cooler/freezer and warmer can be used with most
food and drinks, either cold or hot. Use with standard
household containers or ready-to-use food and drink
packaging.
MAINTENANCE
Your Black & Decker tool has been designed to operate over
a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.
From time to time wipe the appliance with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do not
immerse the appliance in water.