Spectrum Chart - Galaxy Innovations ComboF DVB-S Manual De Instrucciones

5.4. S C
PECTRUM HART
This menu will show the spectrum chart of setting
frequency range on current cable line. Press [/] to
switch curser focus between Start Frequency, LNB Type,
End Frequency, LNB Power/22K and Current Frequency
Mark.
--K:

--V:

40~70~100: The range of power level. And the range is 0 ~ 100


:
03500:

mark:

04000:

cur:

05150:

Press [/] to switch between LNB types.
Press [OK] button to check whether the current frequency
can be locked or not. A dialog will show the locked
transponder once it locks.
5.5. C
ONSTELLATION
Move the curse to Constellation icon and press OK to select
satellite and transponder for constellation analyzer. See the
figure below:
042.0°E Turksat3/4A:

11096/H/30000:

User`s Manual
Show the 22k status. -–K: 22k off; 22k: 22k on
Show the RF power output status. The values are: 13V, 18V and OFF(--V)
The current frequency curse, press [/] to set the current frequency.
The start frequency of the spectrum chart. Press [OK] to edit it.
The power level value of current frequency
The end frequency of the spectrum chart. Press [OK] to edit it.
The current frequency
The current LNB type mode.
The current satellite. Press [/] to switch between
satellites and press [OK] to enter satellite list to select satellite.
Press [OK] button to select the focused satellite and press
[MENU] to exit from edit menu. All the other parameters on
the menu will be refreshed according to the selected satellite.
The current transponder, press [/] to switch between
transponders
8/18