Replacing Belt - Panasonic MC-UL671 Instrucciones De Operación

Motor Shaft
Arbre du moteur
Eje del motor
Belt
Courroie
Correa
End Cap
Bouchon
Tapa del extremo
Lower Plate
Plaque inféreure
Base inferior

Replacing Belt

Belt
Courroie
Correa
Agitator
Agitateur
Agitador
Agitator
Agitateur
Agitador
Front Slots
Fentes avant
Ranuras frontales
➢ ➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢ ➢ Remove lower plate.
➢ ➢ Remove agitator by carefully lifting
out.
➢ ➢ Remove worn or broken belt.
➢ ➢ Loop new belt around motor shaft
and brush pulley; see illustration for
correct belt routing.
➢ ➢ Clean agitator and reinstall the two
(2) end caps.
➢ ➢ Reinstall agitator back into nozzle
housing grooves.
➢ ➢ After reinstalling the agitator, turn it
by hand to make sure the belt is not
twisted or pinched and that all
rotating parts turn freely.
➢ ➢ Reinstall lower plate. Ensure tabs are
locked into slots.
- 42-