Gerreka JEDI JES100E Manual Del Usuario página 36

5. Selecting remote control decoding type (by default: F)
This menu allows F Fixed Code (LUNA) or r Roller Code (IRIS, LIRA) decoding type to be selected to control automation.
CAUTION: Before changing the decoding type or personalising the code, first cancel all the programmed remote controls.
See the paragraph "CANCELLING REMOTE CONTROLS" to cancel the remote controls.
When personalising the code for Roller Code decoding, press the personalised emitter button (either by pressing the hidden button (LIRA) or
by bridging Pins 1 and 5 (IRIS) of the emitter) whilst r is flashing.
-
Press the key,
5
the display shows
6. Open alarm (default: 0 – function deactivated)
If this function is activated, the device emits BEEPs for 30 seconds when the door remains open for longer than 10 minutes. The alarm is
repeated every 10 minutes. Close to door to interrupt the alarm.
-
Press the key,
6
the display shows
7. Automatic closure (default: 0 – function deactivated)
If this function is activated, the device automatically closes the door after the set period of time.
Prior to closing the door, the device emits BEEPs for 3 seconds.
-
Press the key,
7
the display shows
Select the desired pause time using the + and – keys
F
Press the key: flashes
to indicate Fixed Code
decoding.
0
Press the key: flashes
to indicate that the function
is deactivated
0
Press the key: flashes
to indicate that the
function is deactivated
Press the + or – key
r
to select Roller Code
F
or Fixed Code.
Press the + key to activate
the function: the display
I
shows
Press the + key to activate
the function: the display
I
shows corresponding to
30 seconds
Press the
the settings: the display
34
Press the key to save
the settings: the display
5
shows
Press the key to save
the settings: the display
6
shows
key to save
7
shows