Homeworks HRT-3LD Instrucciones De Instalación página 2

Installation
1.
Find a suitable location for the Lamp Dimmer. Place
the Lamp Dimmer in a convenient and accessible
location.
Note: Lamp Dimmer must be located within 30 feet of
an RF Signal Repeater or an RF Processor.
2.
Turn OFF lamp and
unplug lamp cord from
receptacle.
3.
Plug lamp cord
into back of Lamp
Dimmer plug.
4.
Plug Lamp
Dimmer into any
standard wall out-
let.
DANGER: To avoid risk of electrical shock, do
not open, cut cord or rewire the Lamp Dimmer.
DANGER: Unplug Lamp Dimmer when chang-
ing light bulbs.
CAUTION: This is a POLARIZED cord set. It
has a polarized plug (one blade is wider than
the other). The polarized plug is not intended to
be mated with nonpolarized outlets (having both
slots the same size). A polarized outlet is
intended to mate with a polarized plug in only
one way (the longer slot with the wider blade).
2
5.
Turn lamp switch
ON and operate
Lamp Dimmer.
Local Operation
Pressing the Tapswitch on the Lamp Dimmer will alter-
nately turn the lights ON and OFF.
The ON level will be the level previously set using the
Dimming Rocker to the right of the Tapswitch. The LED
that is glowing slightly brighter than the others indicates
the level to which the lights will turn ON. Press and hold
the top or bottom of the Dimming Rocker to raise or
lower the light level. Double-tapping the Tapswitch will
turn the lights ON to full. Pressing and holding the
Tapswitch for 1/2 second (while ON) activates a 10-sec-
ond long fade-to-off.
Status LEDs
Indicate light level;
glow softly as night
light when lamp is off
Tapswitch
Tap on/off
Dimming Rocker
Press to Brighten
Press to Dim