Taurus Alpatec RABAT 600 Manual De Instrucciones página 12

- Turn the appliance on, by using the on/off main
switch.
-Unit start working
Set power:
- Press to set the power. There are 2 settings,
mean low power and
- Press and then press
There are heating on(showed as which let the
unit start to work) and heating off (showed as
which let the unit stop working) two type timer
function.
Select running mode:
- There are two kind running mode comfort
and economic .They can be set temperature
separately. Press to shift the running mode
MODE
between them.
Set temperature:
- Press and then press
temperature. Normally the unit just showed the
room temperature, the target temperature is just
showed while you are setting it. Target tempe-
rature will be confirmed after 5 seconds twinkle
and return to the showing of room temperature
automatically.
Ion Function:
- Press to run ion function and will be showed
on the screen .
The unit is with anti-frost function. If at stand-by
mode, the unit will heat automatically when tem-
perature reduced to 5ºC and stop heating at 8ºC.
The screen will show
is working.
- The unit is available with remote function. The
remote control is valid with 1.5V LR03 or AAA
battery (not included).
Once you have finished using the appliance:
- Turn the appliance off, using the on/off main
switch.
- Unplug the appliance from the mains.
- Clean the appliance.
Carry handle:
- This appliance has a handle on the side of the
body, which facilitates comfortable transport (Fig.
5).
Safety thermal protector:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- When the appliance switches itself on and off
repeatedly, for reasons other than the thermostat
mean high power.
or to set timer.
or to set target
while anti-frost function
control, check to ensure that there are no obsta-
cles that impede correct air entry or expulsion.
- If the appliance turns itself off and does not
switch itself on again, not start again seek autho-
rised technical assistance.
Cleaning
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Remark: When the appliance is used as a
heater after long periods in storage or after
having been used solely as a fan a small amount
of smoke may be produced. This is not important
and is due to the heater burning dust deposits
which have accumulated on the heating element.
This phenomenon may be avoided by cleaning
the inside of the appliance beforehand through
the grill with a vacuum cleaner or pressurised air.
Anomalies and repair
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
For EU product versions and/or in case that it is
requested in your country:
Ecology and recyclability of the product
- The materials of which the packaging of this
appliance consists are included in a collection,
classification and recycling system. Should you
wish to dispose of them, use the appropriate
public recycling bins for each type of material.
- The product does not contain concentrations of
substances that could be considered harmful to
the environment.