Symmons SCOT/Metering SLS-7000 Serie Manual De Operaciones Y Mantenimiento página 3

Installation / Tools Required
Adjustable Wrench
Water lines MUST be thoroughly flushed BEFORE and AFTER installing the faucet to prevent foreign matter i.e.
copper chips, sand, stones, etc. from clogging and possibly damaging the sealing surfaces of the cartridge.
Notes: 1) Recommended minimum operating water supply pressure is 40 psi.
2) Supply stop valves must have 3/8" O.D. compression outlet.
1) Apply a bead of silicone to the
underside of escutcheon (J).
DO NOT apply silicone bead if using
optional deck plate.
4) Place mounting washer (P) and
locknut (Q) onto faucet body (H).
Secure hardware by tightening
mounting nut (R) clockwise.
H
1
P
2
Q
3
R
Allen Wrench: 2.5 mm
2) Optional: Install mounting gasket (L)
and deck plate (K) to deck sur-
face with flat in center hole facing
towards back of sink. Secure with
mounting hardware (M, N & O).
K
J
1
M
N
O
3
5) Connect washer (S) and mechanical
mixing valve (U) to bottom of faucet
body (H). Make connection to water
supplies using appropriate fittings.
S
4
U
1
L
2
3
3
H
1
2
4
3
Silicone
3) Install faucet body (H) and
escutcheon (J) to deck surface.
OPTIONAL
6) Remove aerator (G). Open cold
supply, holding down handle (A) for
10 seconds. Open hot supply and
repeat above procedure. Allow fau-
cet to shut off and replace aerator.
2
A
G
Plumber Tape
H
J