MTD Yard Machines 31A-020-900 Manual Del Operador página 12

REPLACING THE PLATE
Use only original equipment manufacturer replacement
parts.
WARNING:
always turn your unit off and unplug it
before you perform maintenance.
1. Place the unit on the ground or on a work bench.
Position the unit so the vanes and rotor are facing up.
2. Beneath the rotor, locate the 3 screws (A) securing
the plate (B) to the housing. Remove them using a
#T20 Torx bit or flat blade screwdriver. (Fig. 10)
3. Remove the scraper and discard it appropriately.
4. The new scraper will snap into place. Once in place,
attach it to the unit by reinstalling the 3 screws.
A
STORAGE
1. Allow the motor to cool before storing.
2. Store the unit locked up to prevent unauthorized use
or damage.
3. Store the unit in a dry, well-ventilated area.
4. Store the unit out of the reach of children.
MAINTENANCE INSTRUCTIONS
To avoid serious
personal injury,
B
Fig. 10
CLEANING
WARNING:
always turn your unit off and unplug it
before you clean or service it.
Use a small brush to clean off the outside of the unit. Do not
use strong detergents. Household cleaners that contain
aromatic oils such as pine and lemon, and solvents such as
kerosene, can damage plastic housing or handle. Wipe off
any moisturer with a soft cloth.
TRANSPORTING
1. Secure the unit while transporting.
2. To move the unit, grasp it by the top and middle front
handles.
11
To avoid serious
personal injury,