Check Before And After Use; Check Before Use; Check After Use - Nidek LE-700 Manual Del Usuario

Check before and after Use

Check before use

WARNING
• Be sure to check the instrument before every use. It is recommended that a checklist be prepared and the
check results recorded.
• Before turning on the power switch, be sure to check the instrument, power plug, wall outlet, and wheel
cracks.
Failure to do so may result in injury, accident, or instrument malfunction.
1
Connect the power cord to the power inlet.
2
After confirming that the power switch is
turned off
a wall outlet.
3
Confirm that instruments connected to the
LE-700 using the RS-232C cable or USB
cable are turned on.
4
Is the amount of processing water in the tank proper?
The water level must be between the Max and Min lines inscribed on the tank.
If processing water becomes very dirty, replace it. Failure to do so may decrease the accuracy of pol-
ishing.
5
Check visually that wheels are not be chipped or cracked.
WARNING
• Should the wheels be chipped or cracked, immediately stop the instrument and contact NIDEK or your
authorized distributor.

Check after use

Be sure to check the following after use of the day.
It is recommended that a checklist be prepared and the check results recorded.
Is the power turned off?
•
Is the processing chamber clean?
•
Is the instrument free from dirt or damage?
•
Are the display and lens table clean?
•
Are all the accessories accounted for and free from damage?
•

"Accessories" (page 14).
10
, connect the power cord to
Power switch
Power inlet
Power cord