Sage Fast Slow Pro BPR700 Guía Rápida página 4

distance of 20cm away from
walls, curtains, cloths and other
heat sensitive materials.
• Do not place this appliance on
or near a hot gas or electric
burner, or where it could touch a
heated oven.
• Do not operate the appliance on
a sink drain board.
• Do not place the cooker on
a stone bench top when it's
cooking. This is due to bench
tops being sensitive to uneven
heat and may crack if heated
locally. If you would like to cook
with the slow cooker on the
bench top, place a chopping
board or heat proof mat
underneath the cooker.
• Do not place anything, other
than lid, on top of the cooker
when assembled, when in
use and when stored.
• Do not use the lid handle
to carry the appliance.
• Before placing removable
cooking bowl into stainless
steel base ensure the base
of bowl and the base of the
appliance is dry by wiping
with a dry soft cloth.
• Do not use a damaged
removable cooking bowl.
Replace before using.
• Do not place food or liquid
directly into the stainless steel
base. Only the removable
cooking bowl is designed to
contain food or liquid.
4
• Before use, always check
pressure release valve and
safety locking pin for clogging
and clean if necessary. Check to
make sure the safety locking pin
moves freely from under the lid.
• Do not touch the pressure
release valve whilst in use.
• Use only recommended STEAM
RELEASE to depressurise
cooker after use.
• Do not use harsh abrasives,
caustic cleaners or oven
cleaners when cleaning this
appliance. Keep the appliance
clean and refer to care and
cleaning section.
• Do not leave the appliance
unattended when in use.
IMPORTANT SAFEGUARDS
FOR ALL ELECTRICAL
APPLIANCES
• Do not use this appliance
if it is worn, has been dropped
or is damaged in any way.
• Unwind the power cord fully
before use.
• Do not let the power cord hang
over the edge of a bench or
table, touch hot surfaces or
become knotted.
• Connect only to a 220–240V
power outlet.
• Always turn the appliance to
the OFF position, switch off at
the power outlet, remove the
plug and allow all parts to cool
before attempting to move the