Tabla de contenido
Publicidad
Installation and Setup
Read the ENTIRE IMpORTANT
SAFETy INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Mounting the Winch
1. The plate must be rated to at
least the winch's capacity.
2. Align the winch perpendicular to center
line of the vehicle at the desired location,
and mark the locations of the winch
base holes. Compare the dimensions
of the marked holes to Figure D.
3. Before drilling, verify that the installation
surface has no hidden components or
structural pieces that will be damaged.
NOTE: This winch can generate extreme forces. Select
a location that can withstand the rated capacity without
damage or weakening. Steel reinforcement plates may
be needed or a certified welder may need to weld on
additional bracing depending on the mounting location.
4. Drill holes appropriate for the hardware
at the marked locations.
5. Install the winch using hardware described
under Specifications on page 2.
Mounting Winch components
1. Mount solenoid box, switch controller, and
socket lead in proper locations so that:
a. Winch components are close enough to each
other to allow wires to be routed properly.
b. Vehicle component operation
is not interfered with.
c. Vehicle components are not damaged
by drilling or driving screws.
Page 8
For technical questions, please call 1-888-866-5797.
15.55 in. / 395mm
5.31 in. / 135mm
Figure D: Winch Dimensions
d. Winch components will not be damaged by
stresses caused by vehicle operation.
2. Mark the locations where the screw holes will be.
3. Verify that the installation surface has no
hidden components or structural pieces
that will be damaged before drilling.
4. Drill pilot holes for the mounting screws.
5. Secure in place with mounting screws.
4.72 in. / 120mm
4*Ø8.5mm
6.61 in. / 168mm
Item 68144
Publicidad
Tabla de contenido
