Solcrafte 100 Manual De Instrucciones página 7

Assembly instructions
Istruzioni di montaggio
Instructions de montage
Instrucciones de montaje
Instruções de montagem
Connections and Piping
tional sealing material may be used on the collector connections (e.g: hemp, PTFE tape ...), only the seals that have
in order to prevent the connector from being damaged. Use a torque wrench to tighten the connection and do not
temperatures of at least 100 °C.
Collector Circuit Pipe Insulation
The pipes must be insulated with a suitable UV resistant material of the appropriate thickness in order to reduce heat
loss and protect the pipes from freezing. Make sure that the valves are not insulated to ensure perfect functionality, in
case if you make insulation on the valves then you don´t get any warranty.
Collector inclination/general information
The collector is suitable for an inclination between 10 º and max. 75 º. The collector connections and venting openings
must be protected so that water and contamination such as dust cannot enter them. A vertical installation to ridge is
forbidden.
Guarantee
GREENoneTEC warrants that the products supplied are free of defects for a period of 2 years. Accessories such as
valves, heating element and antifreeze element are not covered by this warranty. The warranty period starts on the
production date shown on the typeplate of the product. Preconditions for warranty are assembly, installation, mainte-
nance done by professional contractors according to the installation instructions supplied as well as proper documen-
tation. Excluded from the warranty are defects and damages due to corrosion (see installation instructions for critical
been supplied by GREENoneTEC. No liability will be assumed for any use not as intended or improper alteration of
assembly components as well as for consequences thereof, likewise also for failure to properly comply with the instal-
GREENoneTEC (www. greenonetec.com) apply.
All details and instructions in the installation instructions relate to the current state of development. Illustrations used
are symbolic representations. These installation instructions contain proprietary information that is protected by cop-
yright. Due to possible typographical and printing errors, but also due to the necessity of continuous technical altera-
tion, liability for the correctness of content of the installation instructions is excluded.
7
EN