Charging The Jumpstarter - Omega Lift PRO 80600 Manual De Piezas E Instrucciones De Funcionamiento

Encendedor con pinzas y suministro eléctrico portátiles
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CHARGING THE JUMPSTARTER

* At Home
1. Insert the USB wall adapter provided into an outlet and insert the USB plug into the wall
adapter. Insert the micro USB plug into the Jump Starter charging port.
2. The LED's flash individually during charging. The unit is fully charged once all 4 power LED's
are on.
3. Charge time to full capacity is based on size, see Specifications table for details.
* In A Vehicle
1. Ensure that the vehicle electrical system is 12V. Do Not attempt to charge the unit from a 24V
vehicle system.
2. Insert the USB plug into an appropriate 12V charging socket with USB output (not included).
Insert the micro USB plug into the Jump Starter charging port.
3. The LED's flash individually during charging. The unit cell is fully charged once all 4 power
LED's are on.
* From A Desktop Computer or Laptop
1. Insert the USB plug into the USB port of the computer with the computer turned on. Insert
micro USB plug into the Jump Starter charging port.
NOTICE: To maintain the internal battery of the equipment, charge the unit as soon as possible
after using to start a vehicle or to charge batteries in other electrical equipment .
NOTICE: If the product is not used for a long period of time, fully charge the unit then store it.
Charge once every 3 months.
OPERATIONAL GUIDANCE
* Power Indicator
1. Press the power button to show power indicator light, see below.
Power Indicator
Battery Capacity
2. To ensure optimum condition of unit battery, charge fully as soon as possible after use.
3. If the power indicator light remains off after switching to the "on" position, the unit cell is fully
discharged. Please charge the unit as soon as possible to avoid damage.
Jump Start 12V for Gasoline Engines under 5 Liters (310 in³)
1. With a minimum of 3 power indicator LED alight, this unit can successfully jump start a 12V
petrol vehicle with engines up to 5 L. Charge the unit immediately after use.
2. Before attempting to jump start a vehicle, it is advisable to turn off all vehicle electrical appli-
ances, such as radio, air conditioning, internal and external lights etc.
3. Insert the larger Jump Starter cable block into the 12 V Jump Starter socket.
4. Connect the red clamp of the Jump Starter cable to the RED positive (+) battery cable and
the black clamp to the BLACK negative (-) battery cable. The green light on the cable top-box
will light when the clamps are correctly fitted to the vehicle battery cables. The red light on the
cable top-box will light if the clamps are incorrectly fitted to the vehicle battery cables.
IMPORTANT: If the red light is on the cable top-box then check and re-fit the clamps to the
vehicle battery before attempting to start the engine.
5. If the green light is on the cable top-box then you can turn the vehicle ignition on and start the
engine.
6. After the vehicle engine is started, the cable top-box flashes and cuts off the power circuit to
invoke inverse charge protection.
7. Once the Jump Starter is connected to the vehicle battery, the cable top-box begins to count.
If the time exceeds 45 seconds and the cable top-box enters dormancy mode showing a
slow flash red light. Just remove the red clamp from a vehicle battery and connect it back.
The green light illuminates again and then users can start the vehicle engine.
IMPORTANT: Operational guidance is continued on the next page. Please read ALL the
instructions before using the unit to avoid damage to the unit or property and injury.
Lightless
LED Flash
0%
10%
1 LED
2 LED
25%
50%
3
3 LED
4 LED
75%
100%

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pro 80600r

Tabla de contenido