Configure Your Computer - Steren COM-840 Guía Rápida

2.4. Restore to Factory Default
If the router ever freezes in a setting change process or if you can't access it
because you can't remember the IP you have given it or other problem, you
may have to utilize the reset button on the back of the router to put it back
to factory settings. You have to press and hold this button for a few seconds
(2-6s) with a pencil when it is working, then release and it will restore settings
to the factory configuration.
The other way to restore factory settings is through the same user interface
used in setup. Click on 'System management'- 'Restore', and click on the
'Restore' button.

3. Configure Your Computer

You can manage the 300Mbps Wireless-N Broadband Router through the
Web browser-based configuration utility.
To configure the device via Web browser, at least one properly configured
computer must be connected to the device via Ethernet or wireless network.
The 300Mbps Wireless-N Broadband Router is configured with the default
IP address of 192.168.1.1 and subnet mask of 255.255.255.0 and its DHCP
server is enabled by default. Before setting up the router, make sure your
computers are configured to obtain an IP address automatically from the
router by the steps below.
8