Getting Started - Remixd ETPRAUDTWC Manual Del Usuario

English
USER GUIDE FOR REMIXD TRULY WIRELESS EARBUDS
ETPRAUDTWC
Thank you for purchasing one of ReTrak's many top quality accessories.
We would appreciate it if you take a few moments to read through these
instructions. This will help explain the easy and effective way to use
this product and allow it the long-lasting life that ReTrak's products are
designed for.

GETTING STARTED

CHARGING YOUR EARBUDS
IMPORTANT: Your earbuds operate on built-in
rechargeable lithium-polymer batteries. Although
the batteries were fully charged when they left our
factory, like all batteries they can experience some
power drain during periods of non-use. For best
results, we recommend that you charge the
charging case for approximately 2 hours or
until the LED stops blinking.
1. Using the retractable charge cable
included, plug the micro USB connector into
the case and the other end into a USB charger.
1
2. When charging, the light will blink. Upon being fully charged the lights will
remain solid.
3. If the charge is fully depleted, you may need to re-pair the earbuds to each
other and then to your device after charging.
4. Earbuds will notify you with "low battery" when charging is required.
Bluetooth Pairing Instructions
1. Open charging case and pull out both earbuds. They will both start blinking
blue, and then blue and red. After 10 seconds, they will be paired together.
2. Now, only one earbud should be blinking blue and red. This indicates they
are ready to pair to your phone. Open your Bluetooth settings and connect
to "Remixd TW". Once paired, you will hear "Pairing Successful" and the LED
will go back to a slow blue blink. You are now ready to listen.
3. To turn off, just place the earbuds back in the case and close the lid.
Alternatively, you can hold the button on both earbuds for about 5 seconds
until you hear "Power Off".
Earbud Operation:
Power On/Off: Press and hold multifunction button
or 3 seconds
Play/Pause: Press multifunction button once
Answering/Ending Calls: Press multifunction button once
Redial Last Number: Press the multifunction button twice
Reject Call: Press and hold multifunction button for 2 seconds until hearing
"Call Reject"