Kathrein EXI 3591 Manual Del Usuario página 15

Installation and Safety
• The equipment described is designed solely for the installation of satellite
receiver systems.
• Any other use or failure to comply with these instructions will void the
warranty or guarantee.
• The equipment may only be installed in dry areas indoors. Do not install on
or against highly combustible materials.
• WFS 55 units must be earthed when installed. (Cu, minimally 4 mm²)
• The safety regulations set out in the current EN 60728-11 and EN 60065
standards must be complied with.
• Fixings: Screws, max. Ø: 4 mm.
• Connectors: RF connector 75 Ω (series F) according to EN 61169-24.
• Unused RF ports must be terminated with 75 Ω resistors (e.g. EMK 03).
•
. An inner cable conductor
diameter greater than 1.2
mm, or the presence of
burrs may damage the
sockets on the unit.
Current-carrying device.
• Do not open the unit or tamper with it!
• When working on the system always unplug the power supply unit from
the wall socket!
• The device is intended only for wall mounting! Do not install the device
lying fl at or on its top, or operate it in this position.
• Ensure adequate clearance! Clearance all round at least 5 cm!
• Free circulation of air must be possible to discharge the heat emitted by
the unit. Danger of overheating!
• Ambient temperature range: -20 to +55°C
Caution:
• No liquid-fi lled items may be placed on top of the power supply unit.
• The power supply unit must not be exposed to dripping or splashing water.
• The mains plug must be easily accessible and operable.
• The only reliable method of disconnecting the unit from the mains is to
unplug it.
Max. 2 mm
excess
length
Tightening
torque 3.4 Nm
(danger of over-
winding)
3 / 12
Diameter 0.6-1.2
mm free of burrs