Servicing /Maintenance; Clearing A Jam - STOCKade IMPULSE ST-315i Manual Del Usuario

CLEARING A JAM

A typical problem you may encounter is having a
jammed fastener. Because of the unique design
of the ST315i tool, clearing a jammed fastener
is easy. Damage to parts and/or excessive ac-
cumulation of dirt are principle causes of jams.
If a jam should occur, proceed as follows:
1. Remove the battery and fuel cell.
2. Pull the follower back on the magazine until it
locks in the rear position.
3. Remove all fasteners.
(If needed, unlatch the cover assembly and re-
move.)
4. Clear all jammed fasteners.
5. If the tool continues to jam, or you cannot clear
a particularly
an Authorized STOCK-ade Distributor.
If you that the tool's Fan does not operate
after clearing a jam:
Check the condition of your Battery.
If the Handle LED indicator emits a constant red
glow when depressing the tool, recharge the
Battery.
MAINTENANCE
COLD WEATHER OPERATING PRECAUTIONS
Keep the tool in a warm area until you are ready
to use it. If the tool is already cold, bring it into a
warm area, and allow it to warm up before using it.
DO NOT OPERATE THE TOOL WHEN IT IS COLD
UNLESS FASTENERS ARE BEING DRIVEN INTO
A WORKPIECE.
EXTERNAL CLEANING
The external parts may be cleaned as follows:
1. Remove the battery and fuel cell.
ult jam, have it serviced by
.
®

SERVICING /MAINTENANCE

2. Pull the follower back and remove all fasteners.
3. Remove all dirt and grit from the magazine and
nose of the tool.
4. Clean the outside of the tool using a soft cloth
and a mild degreasant like
CAUTION
Never use highly volatile solvents such as gasoline
to clean the tool. Do not allow any solvent to enter
the interior of the tool. Solvents may cause O-rings
to deteriorate, and possibly swell, causing a tool to
malfunction, and creating a possible safety hazard.
5. Important: It is extremely important for safety
reasons that all dirt and foreign materials be
removed from around the Work Contacting
Element . The Work Contacting Element must be
free to move in and out without sticking or binding.
The Magazine and Work Contact Element are all
designed to operate without lubrication.
MALFUNCTIONS
Be alert for tool problems. A malfunctioning tool
must be immediately withdrawn from use and not
used again until it has been repaired by
service technician. Operating a tool which malfunc-
tions is unsafe. Stop using the tool, and have it re-
paired.
SERVICE AND REPAIR
Except as
of this manual, this tool must not be disassembled,
serviced, repaired, or reassembled by anyone except
service personnel. Incorrect servicing, repairs
and assembly of this tool may result in
to the user and/or damage to the tool. Please con-
tact your local STOCK-ade
Distributor for assistance and repair.
SERVICING / MAINTENANCE
n.
y described in other sections
serious injury
sales person, or authorized
®
13